Meucci original for retirement player

W

white1

AzB Silver Member
Silver Member
Must have points…must be straight…classic no dot shaft around 12.5 mm-ima send it in for refurbishment with custom wrap so not concerned about current look. Message me with offerings. I’ll pay PayPal goods and services. I’ll pay fees. Thanks a lot.
 
I have an 84-3 and also an MO-4 w/ the rare red logo. Both being refinished and rewrapped by Meucci. Expecting back by next week. Both sourced from Japan. Can't give 'em away, but willing to discuss when they arrive. If you want a very specific wrap, probably not worth it.
 
Alternatively, I have another 84-3 waiting to be sent in with work request already submitted. Red and green points. Butt is perfectly straight with very tiny nicks and dents that are hard to see and likely resolved completely with refinish. One tiny ding on edge near bumper. Matching shaft is period correct, pre-dot shaft. Shaft has the tiniest bit of wobble (about 1mm gap in center when rolled on the table), but shaft is just straight taper. Pro-taper would easily make it arrow-straight. I don't think shaft is original to the butt. If you line up the joint collar on butt and shaft, the ring design on the shaft is about 1mm wider than on the butt. Hard to see unless you look very, very closely, but want to be transparent.
Wrap is solid white, uncoated wrap with wear and stains, so needs rewrap anyway. Tip diameter at base of ferrule is 12.8mm.
Was really planning to keep this one but probably a good candidate for you, depending on what you want to spend.
 
Last edited:
This one hasn't been refinished, and would be least expensive. Truly, out of all the cues I've bought, this is the best shaft. No staining at all. I was planning white/green wrap to complement the emerald in the points.
1776776818964.png
1776776840835.png
1776776862212.png
1776776888424.png
 
You must log in or register to reply here.
Back
Top