Mint 60"

[MCP]

No Longer Available

Was out on trade and traded back.

Full splice rosewood Into rosewood.
Bob Danielson built a 2nd gen. SS360 Shaft for the
Chuck Starkey butt. - (Bumperless)
Paul Drexler installed the Linen wrap.
-----
Specs---
30/30 split
Butt 15.2 oz (Approximately)
Shaft 4. oz
12.8mm
3/8 x 10
Ferrule - Hydex
Ferrule length .750
Tip Moori J

Shipped lower 48 w/ tracking & insurance -- JpS included (NO TRADES)

Sent from my iPad using AzBilliards Forums mobile app

 

[DamienLuu]

Is the pin his 1/2 inch ?

Gửi từ IM-A870L của tôi bằng cách sử dụng Tapatalk

 

[MCP]

Pin

The Pin is 1 1/4" Long

 

[Shooter08]

If I needed a cue and played LD shafts, this looks like a steal. Always wanted to try both of these builders offerings. This screams player to me.

 

[DamienLuu]

If I needed a cue and played LD shafts, this looks like a steal. Always wanted to try both of these builders offerings. This screams player to me.

Both have very good reputation I believe. Too bad this is a totally wrong time (I've just shipped my stuffs out of US), or I would jump right on this deal.

 

[Shooter08]

Agreed

Both have very good reputation I believe. Too bad this is a totally wrong time (I've just shipped my stuffs out of US), or I would jump right on this deal.

Whoever picked this up, got a hell of a deal, imho.