My New Diamond Professional!

[Matt_24]

You obviously didn't read this entire thread.

Anyway, the answer is yes, three times.

How did it feel?

 

[DrCue'sProtege]

How did it feel?

Four times now.

Anytime I run a rack it feels good. Just wish I could do it more often. I hose up 2-3 times as many chances as I get out.

 

[DeeDeeCues]

No one ?

The beams are the support, transferring the load to the floor through the legs. Either they are strong enough, or they aren't. The strength is dictated by the cross-section (mostly the height) of the beam. The only ways to get more support are: Larger beams; more legs (shorter unsupported span); stiffer beam material.

 

[SBC]

Read the entire thread. Hopefully you have a brain and can understand. With my Insomnia - I take Ambien - I was up all night Friday night, didn't get any sleep at all. Then after the 4.5 hour install that finished about 1:45 I was soooo tired and hungry I just couldn't hardly play. So, first things first. Which was to fix my lunch since I had not had anything to eat the whole day.

When can I come give you the 4 and out?

 

[Matt_24]

Four times now.

Anytime I run a rack it feels good. Just wish I could do it more often. I hose up 2-3 times as many chances as I get out.

Do you think you'll break and run a 5th rack today?

 

[derangedhermit]

No one ?

Look at photo 2 in the OP. The middle beam has the same amount of support as the beams on either side, in that it is resting on the arches at either end. The side beams do sit right over the feet, so I guess the question is if the arches are stiff enough so that they don't sag in the middle. I have the curved arches, and he has the squared off arches. The arches are deep, so very stiff.

Also the three long beams are all bolted to the short beams at each end of the table, so those cross beams would have to bend along with the arches.

Any floor that's not a concrete slab is much more likely to sag than the Diamond Pro table.

 

[TheGrandWazoo]

Here is a different angle on the Diamond pro. There is enough support for 3 sets of slates. The last possible thing I would be worried about is any sagging. The table is a tank!

 

[straightline]

Isn't the middle beam less prone to sag by virtue of its cut?

 

[maha]

thats the cheapest parts of the table.

 

[TheGrandWazoo]

I think it has more to do with position and thickness. Nothing is gonna sag due to the slates being laid out across the width not the length. The slate frame “beams” are incredibly stout. The support it provides relative to the pound per square inch is surley overkill, and I respect that…

 

[DrCue'sProtege]

Any floor that's not a concrete slab is much more likely to sag than the Diamond Pro table.

That's why years ago I had six (6) extra floor joists installed right under where the legs would sit. Never had a problem with the Gold Crown IV not being level. So far so good with the Diamond Professional.

 

[dendweller]

Here is a different angle on the Diamond pro. There is enough support for 3 sets of slates. The last possible thing I would be worried about is any sagging. The table is a tank!

View attachment 887197

Any minute sagging would be taken care of by the leveling system.