Need 2 Shafts Made, Need Help

DEACON

DEACON

AzB Silver Member
Silver Member
I NEED TO HAVE TWO SHAFTS MADE. I HAVE AN UNKNOWN MAKERS CUE THAT HAS A RADIAL PIN WITH WHITE PHENOLIC JOINT. i WOULD LIKE A PRETTY STIFF HITTING SHAFT ON BOTH AND SOMEONE WHO CAN MATCH UP THE RINGWORK AND USE THE ORIGINAL RINGWORK FROM THE WARPED SHAFT ON ONE. I WOULD LIKE SOMEONE WITH FAIRLY QUICK TURNAROUND TIME WHO USES REALLY HIGH QUALITY SHAFT WOOD FOR THE JOB. I HAVE TO FIND SOMEONE WITH A REALLY GOOD REPUTATION AND COULD USE ANY ADVICE I MAY RECEIVE. I WOULD LIKE PARABOLIC OR CLOSE TO IT TAPER FOR THIS CUE. IDEAS OF PRICE WOULD ALSO GREATLY ASSIST ME, THANKS AND REGARDS, DEACON
 
DEACON said:
I NEED TO HAVE TWO SHAFTS MADE. I HAVE AN UNKNOWN MAKERS CUE THAT HAS A RADIAL PIN WITH WHITE PHENOLIC JOINT. i WOULD LIKE A PRETTY STIFF HITTING SHAFT ON BOTH AND SOMEONE WHO CAN MATCH UP THE RINGWORK AND USE THE ORIGINAL RINGWORK FROM THE WARPED SHAFT ON ONE. I WOULD LIKE SOMEONE WITH FAIRLY QUICK TURNAROUND TIME WHO USES REALLY HIGH QUALITY SHAFT WOOD FOR THE JOB. I HAVE TO FIND SOMEONE WITH A REALLY GOOD REPUTATION AND COULD USE ANY ADVICE I MAY RECEIVE. I WOULD LIKE PARABOLIC OR CLOSE TO IT TAPER FOR THIS CUE. IDEAS OF PRICE WOULD ALSO GREATLY ASSIST ME, THANKS AND REGARDS, DEACON
Click to expand...


might check with madison bob, maybe Mike Webb, or eric crisp of sugartree cue's.

Know bob likes a parabolic taper on his shafts, so may be able to get a quicker turn around. Won't hurt to give him a call number is in the bluebook, web page is down currently. Email is dagriffin@seidata.com

Thousands of cuemakers to pick from, just gave you three.
 
I would say to use Ed Young who's in our area, except for the fact that you need a quick turn around time. Btw, that looks like one of Ed's cues in your avatar, is it? Like that purpleheart. You could always try Mueller's, they're pretty good and fast, but I don't know if they can match ringwork. Maybe you should just 'call around'.
 
Last edited:
I would call Ned Morris. He makes great shafts and would have no problem matching the ring work. His prices are good too.
 
trueblu8 said:
I would say to use Ed Young who's in our area, except for the fact that you need a quick turn around time. Btw, that looks like one of Ed's cues in your avatar, is it? Like that purpleheart. You could always try Mueller's, they're pretty good and fast, but I don't know if they can match ringwork. Maybe you should just 'call around'.
Click to expand...

I can match any ringwork you throw at me. Unless the ringwork has inlays, there is no extra charge. $80, done in a week to 10 days.
 
First price matters, Dennis Dieckman will have the most shaft selection. He has hundreds of shafts ready to be fit. cuebuilder@cuemaker.com lets not forget about pred.z-2,314 shafts. Or universal smartshafts, or mcdermot i shafts.
 
Mystick Cue Fan said:
for 2 shafts....? :p
Click to expand...

$80 for each. Add $10 for a layered tip and $20 for a sniper or moori. Click the link in the signature for my complete price list.
 
You must log in or register to reply here.
Back
Top