Hello,
In a few days, I will be receiving a new (to me) cue that I will be converting into a breaker. It has a 3/8 X 10 pin and I just bought an OB Break shaft (unfinished joint) for it.
How much should it cost to have the new shaft fit to the cue?
Also, is there a reputable cue maker near Corona, CA that can handle this for me?
Thank you,
Mike
In a few days, I will be receiving a new (to me) cue that I will be converting into a breaker. It has a 3/8 X 10 pin and I just bought an OB Break shaft (unfinished joint) for it.
How much should it cost to have the new shaft fit to the cue?
Also, is there a reputable cue maker near Corona, CA that can handle this for me?
Thank you,
Mike