I posted this thread in the "Ask the Cuemaker" forum and have not received any replies. I was hoping I'd have some better luck here.
In a few days, I will be receiving a new (to me) cue that I will be converting into a breaker. It has a 3/8 X 10 pin and I just bought an OB Break shaft (unfinished joint) for it.
How much should it cost to have the new shaft fit to the cue?
Also, is there a reputable cue maker near Corona, CA that can handle this for me?
Thanks all,
Mike
In a few days, I will be receiving a new (to me) cue that I will be converting into a breaker. It has a 3/8 X 10 pin and I just bought an OB Break shaft (unfinished joint) for it.
How much should it cost to have the new shaft fit to the cue?
Also, is there a reputable cue maker near Corona, CA that can handle this for me?
Thanks all,
Mike