Need a weight bolt for Joss cue
- Thread starter Klopek
- Start date
joss weight screw
if your joss is like mine , you can go to the hardware store . look for 1/2 inch set screw takes 1/4 allen
wrench , i bought one with tee handel. if can't find set screw check out
threaded rod . cut for weight you need make sure threads are same .
i think mine had 13 pi thread . cut slot for straight screw driver .
works good for me . i don't like to hear the weight rattle .
i allways wipe a little silicone in threads in cue to keep tight .
glue will work , but it may never come out. you can work with the
silicone no need to over kill . squeeze out about a 1/4 inch dot that is all it needs. hope this helps john107:anderson sc
if your joss is like mine , you can go to the hardware store . look for 1/2 inch set screw takes 1/4 allen
wrench , i bought one with tee handel. if can't find set screw check out
threaded rod . cut for weight you need make sure threads are same .
i think mine had 13 pi thread . cut slot for straight screw driver .
works good for me . i don't like to hear the weight rattle .
i allways wipe a little silicone in threads in cue to keep tight .
glue will work , but it may never come out. you can work with the
silicone no need to over kill . squeeze out about a 1/4 inch dot that is all it needs. hope this helps john107:anderson sc