Need help!! I have a unknown cue hand made inlays and veneers

$$PAPINO$$

Registered
I have a cue that i'm trying to figure out the maker of.. It very diffrent.. Its mostly made of maple with some other woods that i'm not sure of...i'm pretty sure that the joint is made of derlin, and it has a radial pin similar to a dale perry but a hair larger out side diameter but the threads are the same, a dale perry shaft will go about half way on before its to tight to turn..it has 6 points that are all very sharp, 3 high and 3 low, they are shorter points than you see these days.. They are also just a bit off from being the same lenth...the butt is very diffrent which is what caught my eye.. The butt cap does appear to have been changed or worked on... Please let me know if you can help... Thanks david 501-317-8508
 

Attachments

  • cue 001.jpg
    cue 001.jpg
    97.8 KB · Views: 368
  • cue 004.jpg
    cue 004.jpg
    100.1 KB · Views: 374
  • cue 006.jpg
    cue 006.jpg
    99.1 KB · Views: 376
  • cue 017.jpg
    cue 017.jpg
    102.8 KB · Views: 382
  • cue 013.jpg
    cue 013.jpg
    102.5 KB · Views: 371
Here are more pics
 

Attachments

  • cue 003.jpg
    cue 003.jpg
    104.2 KB · Views: 371
  • cue 008.jpg
    cue 008.jpg
    100 KB · Views: 359
  • cue 009.jpg
    cue 009.jpg
    109.3 KB · Views: 363
  • cue 010.jpg
    cue 010.jpg
    99.1 KB · Views: 369
  • cue 012.jpg
    cue 012.jpg
    100.4 KB · Views: 358
Back
Top