Old school Cuetec SST shafts...what thread size???

[Maniac]

Back before carbon fiber and R360 LD when Cuetec only made the SST fiberglass coated shafts, what was the (then) standard thread size they used? I believe it was considered proprietary at that time.

 

[garczar]

Back before carbon fiber and R360 LD when Cuetec only made the SST fiberglass coated shafts, what was the (then) standard thread size they used? I believe it was considered proprietary at that time.

what joint screw

Does anyone know what the thread is on this joint screw in a Cuetec cue. The model # is CT263 and has an SST shaft. It looks like a 14 tpi but is larger than a 5/16 and smaller than a 7/16. The threads measure about .359. Thanks Kim

forums.azbilliards.com

 

[lakeman77]

I had older SST, 8-9 years ago. 3/8x14, same as the new ones. The joint diameter of the older is smaller, maybe 20mm. I think the new ones are 21.30mm. If someone knows different please correct me.

 

[NathanDetroit]

I had older SST, 8-9 years ago. 3/8x14, same as the new ones. The joint diameter of the older is smaller, maybe 20mm. I think the new ones are 21.30mm. If someone knows different please correct me.

That is pretty much correct, but the new pin is very tight on the old shafts

 

[j2pac]

I had older SST, 8-9 years ago. 3/8x14, same as the new ones. The joint diameter of the older is smaller, maybe 20mm. I think the new ones are 21.30mm. If someone knows different please correct me.

Correct. Same pin, different joint diameter. The older joint diameter is referred to as the legacy joint diameter. It is 20mm (.787 ish).