old valley rails

[Dave38]

I am looking to replace the rubber on an old set of rails from an old valley table that I recovered for a customer last year. I swapped out the old ones with new ones as the rubber was as hard as the wood. The wood is still fine, so I figure I can reuse these for a future table job. Don't remember the model table it was, but am having trouble matching the proper profile. The old rubber is .804" wide by 1.090" height. I have a piece of K66 and it is larger on both measurements. The closest I can get to these is the U23, but even that is slightly different. The only label is ' Crystal' and stamped in red on the top is 0C02.
Any help appreciated.
Thanks,
Dave38

 

[realkingcobra]

I am looking to replace the rubber on an old set of rails from an old valley table that I recovered for a customer last year. I swapped out the old ones with new ones as the rubber was as hard as the wood. The wood is still fine, so I figure I can reuse these for a future table job. Don't remember the model table it was, but am having trouble matching the proper profile. The old rubber is .804" wide by 1.090" height. I have a piece of K66 and it is larger on both measurements. The closest I can get to these is the U23, but even that is slightly different. The only label is ' Crystal' and stamped in red on the top is 0C02.
Any help appreciated.
Thanks,
Dave38

Why not just check with Penguin rails, and keep it simple.