Here is a new, never used or chalked Vintage Series CS431 cue with 2 shafts that I just got in. This is a limited edition tribute cue that is variation of Frank Paradise’s very fancy Diamond King model that is made by Adam of Japan and includes a COA. The butt sleeve and points and top grade Gaboon Ebony. In addition to the deco rings at the ends of the butt sleeve and between the points and wrap there is a total of 80 mother of pearl inlays in the beauty. The cue has a very tight fitting 5/16x14 compression fit joint. The quality, point work, and inlay work in this cue is as nice as anything I have ever seen from Adam/Helmstetter. The pictures do not do this cue justice. This cue retails for $1000.00 and the extra shaft is an additional $125.00. The cue and shafts are dead straight together or apart. Butt is 29 inches long and weighs 15.02 ounces. Shaft 1 is 29 inches, 12.94 mm, and weighs 4.36 ounces. Shaft 2 is 29 inches, 12.91 mm, and weighs 4.52 ounces. The balance point is 19.0” from the butt with the lighter shaft. The cue includes a 3 piece set of Picone delrin joint caps.
Note - There is a weight bolt in the butt that weighs .90 ounces. I can adjust the weight down by as much as .90 ounces or add some weight if desired.
Priced to sell at $660.00 including shipping and insurance in the CONUS. Please feel free to PM or email me at ****@***.com if you have any questions.
Thanks,
Pat
Note - There is a weight bolt in the butt that weighs .90 ounces. I can adjust the weight down by as much as .90 ounces or add some weight if desired.
Priced to sell at $660.00 including shipping and insurance in the CONUS. Please feel free to PM or email me at ****@***.com if you have any questions.
Thanks,
Pat
Attachments
Last edited:
