Phenolic Tip

[Scott44]

Do you need a special tool to cut a phenolic tip? I bought a mid America Cue Lathe a few months back and have put several tips on since then but they were all leather tips. A guy in our pool league wanted me to take his old phenolic tip off and put a new one on. I just tried to make a small face cut on the old one and I couldn't cut it at all with a carbide blade insert.

Any help appreciated.

Thanks

 

[ratcues]

You should be able to cut it with carbide.

 

[Scott44]

You should be able to cut it with carbide.

That's what I thought. I will put a new blade in and try again but this blade hadn't been used very much. Are there any tips made of something harder than the phenolic ones?

 

[ratcues]

G10 is harder but I wouldn't recommend it on a break cue.

Check the center height of your cutter. Too high or too low will cause issues, especially with hard materials.

 

[Scott44]

G10 is harder but I wouldn't recommend it on a break cue.

Check the center height of your cutter. Too high or too low will cause issues, especially with hard materials.

Will do.

Thanks for the help.