point groove cutter

[Dave38]

I'm looking for a 1/4" shank router bit to cut the point grooves. I have one now, but it only goes to about 5/8 wide for points. I'd like one that can do 3/4" roughly. So far I can only find 1/2" shank ones. any supplier ideas welcome.
Thanks,
Dave

 

[Chris Byrne]

I think Chris hightower and brianna have them. Chris.

 

[Tony Zinzola]

I might have one unused. Not sure where you are in Mass, but if I do, you might be able to pick it up.

 

[Tony Zinzola]

I have the one Chris sells still unused. I put the calipers on it and it's about .750 at the widest cut. Not sure if this is the same one you have or not. If you want it, I'm in Marlborough and you can swing by to pick it up.

If that's what you already have, you can get bigger ones here:

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_ogee.html

 

[Dave38]

I have the one Chris sells still unused. I put the calipers on it and it's about .750 at the widest cut. Not sure if this is the same one you have or not. If you want it, I'm in Marlborough and you can swing by to pick it up.

If that's what you already have, you can get bigger ones here:

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_ogee.html

The one that I have is 5/8 tall for the widest cut, unless I bury it then trim off the ridge it creates. I'll pm you about yours and thanks for the link for those other ones. Thanks,
Dave

 

[cuemaker03]

Grizzley tools has the cutter you need.