Porper model B

[G's Cues]

I am looking for some info on what quick change tool post that would be good to change out the x-y post that came with the lathe. Thanks in advance George

 

[josie]

I put a Phase II 100 series Q/C post on my Porper and it works great. You will need to drill and tap the bottom plate that fits in the Porper carriage to accomodate the new threaded post that fits through the Phase II. I believe I also added a 1" spacer to get the height close and then fine tune with the tool holders.

Eric

 

[G's Cues]

I put a Phase II 100 series Q/C post on my Porper and it works great. You will need to drill and tap the bottom plate that fits in the Porper carriage to accomodate the new threaded post that fits through the Phase II. I believe I also added a 1" spacer to get the height close and then fine tune with the tool holders.

Eric

Thanks for the info I will check into it. George