Q-Werks Cues

ragbug74

ragbug74

Next NYTimes Best-Seller!
Silver Member
Here's the first cue to "leave my shop".....built for Frankenstroke.......

Details:

Rosewood forearm, flame veneers, cocobolo butterfly points.
Cocobolo buttsleve, mahogany phenolic rings/joint/buttcap.
Flat-laminated shaft, textured brown leather wrap.
3/8-10 pin, flat-faced joint.
PPG auto clearcoat finish which needs another buffing as he's been playing with the cue for a few weeks.
Thanks to Varney for the brown bumper to top it all off!

DFC1_Full_Cue.JPG


DFC1_Buttsleve.JPG


DFC1_Forearm.JPG
 
Last edited:
very nice. i might opt for a black wrap to better tie in the black streaks in the cocobolo.
 
I dig it, I don't know if I would have gone so thick with the brown rings, but it is a beautiful cue.
 
Ragbug surprised me with this cue 6/14/08. I had no idea his cuemaking abilities had progressed this far.

I though it unusual to combine rosewood and cocobolo. You would think the 2 reddish woods would clash, but they are so close in shades of red that it works very well.

He purposely has no black components on this cue, right down to the bumper.

It hits hard, due to the laminated shaft. Its dead straight, with little flex.

Thank you, Ragbug. I love it!
 
You must log in or register to reply here.
Back
Top