All,
I've got a buddy who just picked up a GCIII and has a potential problem with the feet / levelers. He says that the nuts on the bottom will not thread all the way, that they get to a certain point and then just spin and spin.
Does anyone know if this is normal behavior for this table? If not, is there a remedy for the condition?
I'm also posting this in the Table Mechanic's forum, but though some of you might have some insight.
Thanks,
R.S.
I've got a buddy who just picked up a GCIII and has a potential problem with the feet / levelers. He says that the nuts on the bottom will not thread all the way, that they get to a certain point and then just spin and spin.
Does anyone know if this is normal behavior for this table? If not, is there a remedy for the condition?
I'm also posting this in the Table Mechanic's forum, but though some of you might have some insight.
Thanks,
R.S.