Rail angle

billy-ks

billy-ks

AzB Silver Member
Silver Member
I have a GC1 that I am redoing the rails on. I have new Brunswick Super speed rail rubber for. I'd like to tighten the pockets and deepen the shelf on the slate. Could someone tell me the rail angle of a diamond pro and a Brunswick.

Thanks
 
billy-ks said:
I have a GC1 that I am redoing the rails on. I have new Brunswick Super speed rail rubber for. I'd like to tighten the pockets and deepen the shelf on the slate. Could someone tell me the rail angle of a diamond pro and a Brunswick.

Thanks
Click to expand...

If you're talking about the sub-rail bevel that you mount the cushions on, Diamond and Brunswick are not the same. If you're talking about the pocket angles, Diamond and Brunswick are not the same there either. Could you explain a little more about what you want to know?

Glen
 
I am talking about the pocket angle. Being I am going to tighten the pockets I would like to copy the diamond table if possible.
 
51 degrees on a miter saw, or 141 degrees by gage depending on how you want to look at it, with a 15 degree down angle if you want to copy Diamond's pro cut pocket;)
 
You must log in or register to reply here.
Back
Top