Re-steady rest

[chuckpilegis]

A few people wanted to know if I could sell them one and how much.
So I wasnt doing anything yesterday and made one up
Its about 22 inches long and has a 16 inch travel
You can put it behind a taig or HF mini,just figure on the height you need
60.00 plus 15.00 shipping (priority mail conus)
Dont have paypal so it would need to be PO money order or check

 

[klatsch1971]

shipping

Hallo!
This is a great tool for the repair of houscues. Send you this tool to germany?
What cost the tool incl. shipping?
Thanks for your answer!
Regards
Jan

 

[rhncue]

Hey Chuck, What is the bearings I.D.?

Dick

 

[chuckpilegis]

Hey Chuck, What is the bearings I.D.?

Dick

6005 sealed bearing and the inside diameter is 25mm

 

[Palmetto cue]

That looks good! You would have a great laugh if you saw my set up for house cues. :grin:

 

[Morgantownfats]

That looks like the nuts for a 7x10 set up! May have to get one of those from you Chuck

 

[msquared]

Sweet...could you make one for shafts? and how much.


Thanks Mike

 

[chuckpilegis]

Hallo!
This is a great tool for the repair of houscues. Send you this tool to germany?
What cost the tool incl. shipping?
Thanks for your answer!
Regards
Jan

The last time I shipped out of the country I shipped a couple of shafts.
Shipping was close to 50.00 priority mail and this will be heavier

 

[chuckpilegis]

Sweet...could you make one for shafts? and how much.


Thanks Mike

This is pretty much like my origional one that I use for shafts on my retipper

 

[msquared]

for shafts.

does it come with the rubber to hold the shafts? If it does it could be used for both house cues and just shafts. I'm interested if it can be used with shafts. the red lathe in the picture is the same one i have. from Hobo freight.

Thanks Mike. M. please call me 209-918-6378.

This is pretty much like my origional one that I use for shafts on my retipper

 

[forceXfollow]

Are you still making/selling these? Thanks


Sent from my iPhone using Tapatalk