Realkingcobra rails in the Memphis area!!!

M

memphisbill

"Southaven Rec Center"
Silver Member
Correctly recovered rails with Simonis 860 Green.
--------------------------------------------------------------------------------

These are a few pictures of some GC 2 rails I replaced the rubber on with Artimis Intercontinental K55 rubber, extended the rails subrails, tightening the pockets to 4 3/8ths corner, and 4 7/8ths side pockets. Then I installed the cloth. Ready for shipping now.

One set will be installed at SOUTHAVEN RECREATION CENTER located in Southaven,ms (662-342-0230) and one set will be in Memphis at HIGHPOCKETS (901-761-1583).

I hope any of you AZER'S located in the Memphis area will come by and try these out. BILL ROWSEY
 
memphisbill said:
Correctly recovered rails with Simonis 860 Green.
--------------------------------------------------------------------------------

These are a few pictures of some GC 2 rails I replaced the rubber on with Artimis Intercontinental K55 rubber, extended the rails subrails, tightening the pockets to 4 3/8ths corner, and 4 7/8ths side pockets. Then I installed the cloth. Ready for shipping now.

One set will be installed at SOUTHAVEN RECREATION CENTER located in Southaven,ms (662-342-0230) and one set will be in Memphis at HIGHPOCKETS (901-761-1583).

I hope any of you AZER'S located in the Memphis area will come by and try these out. BILL ROWSEY
Click to expand...
Memphisbill, I have been thinking of doing the same thing with a Gandy table that I have but was worried about the ball height if it would be the same. I do not see any pictures and does the rubber meet the balls at the same place as K66 rubber?
 
You must log in or register to reply here.
Back
Top