reduce pockets on a GC 4 in Port Charlotte Fl. area.

[mc27out]

Need to reduce pockets and recut openings for the corners of a GC 4 to 4 3/8" no triple shimming. New rails etc. Port Charlotte Fl. area.

 

[ShortBusRuss]

Need to reduce pockets and recut openings for the corners of a GC 4 to 4 3/8" no triple shimming. New rails etc. Port Charlotte Fl. area.

Can't speak specifically as to his ability to do a normal subrail extension, but Wes Burden out of Tampa is good peeps, and I would assume he'd give yah the straight dope on whether he is comfortable with doing the job or no...

http://www.billiardfitter.com/

 

[ShortBusRuss]

Follow up:

While I was looking around for general "shim versus subrail extension" threads, I stumbled upon one confirmed review of Wes Burden doing a good subrail extension-

Contact Mark Gregory, 770-548-4292, there's no one in Florida that is going to do this kind of work right, sorry

I respectfully disagree. Wes Burden is a good mechanic with a solid reputation based out of the Tampa area

He has done a few tables for me including a 9' Brunswick sub rail extension job.

Wes Burden
813 416 2255
wespool66@yahoo.com

 

[mc27out]

Thanks Russ

Haven't posted a lot.
Thanks Russ that was quick, hope someone is closer to Port Charlotte.
I found an old thread about a table mechanic "Tim Pollet"? in Port Charlotte?

 

[Ralph Kramden]

Haven't posted a lot.
Thanks Russ that was quick, hope someone is closer to Port Charlotte.
I found an old thread about a table mechanic "Tim Pollet"? in Port Charlotte?

Take a ride to Veterans Billiards on Veterans highway. It's near route 41.
Ask them for a recommendation. Whoever works on their tables is good.

.