Replacement shaft for dufferin shadow

[brokenarrowjbe]

Any body have the hardware to make a shaft to match a dufferin shadow cue? Looking for 13 mm at the tip with pro taper. Has a black phenolic looking material presently at the joint. Thanks, John

 

[Mase]

If its a shadow the pin should be in the butt and it should be 5/16x14. Any of the standard inserts should work. You will just have to drill it out 5/16 of an inch with an O or P bit to allow for the untapped section.

 

[brokenarrowjbe]

I am not a cuemaker, what is a p or o bit? Thx, John

 

[Mase]

A P bit is .323 and an O bit is .332.