Super rare Richard Chudy here, not a lot of RC3s made with Black & White Ebony nose.
This cue features a very nicely figured black & white ebony forearm with six jet-black ebony points. Four laminates (white/black/white/black). Same design on the buttsleeve, figured black & white ebony w/ six ebony points plus veneers. Square-dotted RC3's signature rings on all position. Genuine black EE leather wrap. LBM ferrule on both the shafts.
G10, 3/8x10 pin. Logo on one of the points in the forearm, one on top of the G10 pin, and signature inside the bumper.
This cue also comes w/ matching wooden butt-side JPs made with the same wood, and 2 delrin joint protectors.
Cue also comes with a custom-ordered matching ringwork with B&W ebony wood extension that cost about $350. The butt was slightly modified in order to made the custom bumper work with the extension. The original bumper does not screw in the butt-side as it was lightly retapped to fit the custom bumper, but the bumper can still fit tight to the inner-side of the buttcap like all other push & plug bumpers.
Specs:
Butt: 15.75oz
Shaft 1: 3.85oz (13.05mm)
Shaft 2: 3.88oz (13.09mm)
Extension: 5.32oz / 20cm (Length)
Condition:
Shaft 1 is lightly used for about 1-2 months, been well-taken care of and reconditioned after being played, slight patina.
Shaft 2 is test-hit, pretty much brand new condition.
Butt is in very good used condition, buttsleeve has a few minor flaws (see the last few pictures on this thread).
Extension has a few dings/dents (also see the last few pictures on this thread).
Price: $OLD shipped express worldwide
Thank you,
TS’s Billiards
This cue features a very nicely figured black & white ebony forearm with six jet-black ebony points. Four laminates (white/black/white/black). Same design on the buttsleeve, figured black & white ebony w/ six ebony points plus veneers. Square-dotted RC3's signature rings on all position. Genuine black EE leather wrap. LBM ferrule on both the shafts.
G10, 3/8x10 pin. Logo on one of the points in the forearm, one on top of the G10 pin, and signature inside the bumper.
This cue also comes w/ matching wooden butt-side JPs made with the same wood, and 2 delrin joint protectors.
Cue also comes with a custom-ordered matching ringwork with B&W ebony wood extension that cost about $350. The butt was slightly modified in order to made the custom bumper work with the extension. The original bumper does not screw in the butt-side as it was lightly retapped to fit the custom bumper, but the bumper can still fit tight to the inner-side of the buttcap like all other push & plug bumpers.
Specs:
Butt: 15.75oz
Shaft 1: 3.85oz (13.05mm)
Shaft 2: 3.88oz (13.09mm)
Extension: 5.32oz / 20cm (Length)
Condition:
Shaft 1 is lightly used for about 1-2 months, been well-taken care of and reconditioned after being played, slight patina.
Shaft 2 is test-hit, pretty much brand new condition.
Butt is in very good used condition, buttsleeve has a few minor flaws (see the last few pictures on this thread).
Extension has a few dings/dents (also see the last few pictures on this thread).
Price: $OLD shipped express worldwide
Thank you,
TS’s Billiards
Last edited:
