Sold Ron Betts Custom Sneaky Pete FS

Sold Item

Rtoron

AzB Gold Member
Gold Member
Silver Member
Custom Sneaky Pete built by Ron Betts brand new just completed. Signed and dated. Four point spliced butt weighs
14.47 oz. Shaft has a pro taper 3.48 oz. with a linen based ferrule and 13mm Triangle tip. Delrin Custom joint protectors included. Cue weighs 17.95 oz. Balance point 17.25".There is no weight bolt. 3/8-10 joint pin. Length of cue is 57.5 ". Cue is straight apart and together. Cue has an exceptional hit. This cue hits as close to a one piece cue as you can get. There is no hard finish on this cue. It is Tung Oiled polished and waxed so you don't have to worry about dinging up a hard finish. If you put a ding in this cue get your wet wash rag and iron out and steam the dent out. Rub a little Tung Oil on and you are good to go. No need to refinish the cue. This is a nice no nonsense player. Asking $SOLD shipped CONUS. I built cues for 20 years and then retired from it but decided to start building some premium Sneakies. Sneakies hit the best because they are the closest thing to a one piece cue. These are hand made cues made one cue at a time. They have a look and quality to them that production cues don't have. My pictures are not that good and don't show the high gloss finish on this cue.
 

Attachments

  • 20221006_174148.jpg
    20221006_174148.jpg
    46 KB · Views: 382
  • 20221006_174204.jpg
    20221006_174204.jpg
    179.5 KB · Views: 390
  • 20221006_174159.jpg
    20221006_174159.jpg
    286.5 KB · Views: 386
  • 20221006_174210.jpg
    20221006_174210.jpg
    196.4 KB · Views: 380
  • 20221019_111101.jpg
    20221019_111101.jpg
    153.8 KB · Views: 113
  • 20221019_111412.jpg
    20221019_111412.jpg
    57.9 KB · Views: 112
Last edited:
Back
Top