RT Custom cue - parts

L

lcbur

AzB Silver Member
Silver Member
Here is something for a cue maker or someone that wants to have a nice cue built.
These are some parts I got from the RT Custom Cue shop after they stopped building cues. RT made some very nice cues. I know because I have some ( not for sale ). All these parts roll straight.

Butt: Sold Fancy birds eye maple and cocobolo finished with no dings. Ring work and Radial pin. 16.472 oz. 29” and 7/8” across collar. It is signed RT 07 on the end butt cap ring. The butt is finished and has No dings or scratches. SOLD

Shaft #1: Sold Unfinished and has same joint collar as butt. 3,809 oz. 29 7/8” long no ferrule. Tip end 13.5 mm. SOLD
Shaft #2: Unfinished with white ring on collar. 4.197 oz. 29” long and 13mm tip.
Shaft #3 finished and looks to have been used. a little . 3.774 oz. 29” long and 13.4 mm tip.

Shafts: #2 and #3 - $75. for both shafts.


Will sell the shafts and butt separatly:
Will start a new thread for Shafts #2 and #3

There is an added picture of the signed butt cap. Thanks

RT cues are high end cues. Very nice
 

Attachments

  • MVC-215S.JPG
    MVC-215S.JPG
    37.2 KB · Views: 1,134
  • MVC-217S.JPG
    MVC-217S.JPG
    36.5 KB · Views: 1,112
  • MVC-218S.JPG
    MVC-218S.JPG
    39.5 KB · Views: 1,092
  • MVC-102S.JPG
    MVC-102S.JPG
    39.8 KB · Views: 1,082
Last edited:
Yep rt don't make cues no more .. 400 for a butt is strong just sell the the whole thing as is, you'll do better....good luck ...
 
The Butt is finished and perfect condition. Much nicer looking than in my pictures. If you buy it and don't like it for any reason send it back for a refund. These RT cues are high dollar cues.
 
Newly listed on eBay and lowered to $350. - ($310. shipped here for AZ buyers before any eBay bids.
 
Someone can use this. The Butt is heavier than I like or I would keep it and have a shaft fit to it. It should be just right for someone. RT cues are Quality and some sold for over $2000.
 
Hi there, what needs to be done to the shafts in order to finish the cue? The all look pretty complete, minus the one that needs a ferrule.
Answer:
The shaft with matching collar is totaly unfinished. It is longer and in the rough and has never had a ferrule or tip put on it. It screws on and is a little bigger in diameter and would have to be fitted to the cue.
The next shaft has no coating on it and has a differen't joint for another cue.
The used finished shaft has a different collar and a little different thread. To tight to screw on the butt.
 
RT shafts

Shafts #2 and#3 are for sale at $75. for both shafts.
 
Last edited:
You must log in or register to reply here.
Back
Top