Rubber bumper type

[Wolven]

I'm trying to replace rubber bumpers on a Dufferin Anniversary table. The old rubber is championship traditional.
It looks like notched side is 1-7/16 and the solid sides 1-1/4.
Actually the solids sides could be 1-1/4 and 1-3/16.
Anyone know if this is k-55 or k-66?
I saw a drawing for K-55 solid sides matched but the notched side was 1-5/16.

 

[realkingcobra]

I'm trying to replace rubber bumpers on a Dufferin Anniversary table. The old rubber is championship traditional.
It looks like notched side is 1-7/16 and the solid sides 1-1/4.
Actually the solids sides could be 1-1/4 and 1-3/16.
Anyone know if this is k-55 or k-66?
I saw a drawing for K-55 solid sides matched but the notched side was 1-5/16.

From the nose of the cushion, measured across the too to the back edge, where it meets the Sumrall, what does that measure?

 

[Wolven]

From the nose of the cushion, measured across the too to the back edge, where it meets the Sumrall, what does that measure?

Thanks for taking the time to help. It looks like either 1-1/4 or 1-5/16, that's the top of the cushion.

 

[realkingcobra]

Thanks for taking the time to help. It looks like either 1-1/4 or 1-5/16, that's the top of the cushion.

Then get some K55 profile cushions, because that's what they are.

 

[Wolven]

Then get some K55 profile cushions, because that's what they are.

thank you I will