THe Espiritu below was test hit a few racks (Less than 10.)
The rear and forearm are nicly figured curley maple.
There are 4 cocobola designs in the butt with mother of pearl ovals in the center.
The wrap is brown Irish linen with white specs.
the forarm has 4 sharp cocobola points with 2 thin veneers a Blue and yellow outlined in ebony.
at the base of each point is a small mother of pearl oval.
the cue weight 19.3 oz
shaft is 13mm.
Here are also some specs from Russ in an email answering a few questions:
Carl
The taper is 10inch pro taper
The balance point
I usually measure from the top of wrap
1.5inches
Ferrule material is linen phenolic
I make all the parts for each cue
I buy ferrule material and make the ferrules
Joints etc
The ferrules,joints,butt cap,joint rings are all threaded on
the cue
I build each cue to last a lifetime
Russ

http://
The rear and forearm are nicly figured curley maple.
There are 4 cocobola designs in the butt with mother of pearl ovals in the center.
The wrap is brown Irish linen with white specs.
the forarm has 4 sharp cocobola points with 2 thin veneers a Blue and yellow outlined in ebony.
at the base of each point is a small mother of pearl oval.
the cue weight 19.3 oz
shaft is 13mm.
Here are also some specs from Russ in an email answering a few questions:
Carl
The taper is 10inch pro taper
The balance point
I usually measure from the top of wrap
1.5inches
Ferrule material is linen phenolic
I make all the parts for each cue
I buy ferrule material and make the ferrules
Joints etc
The ferrules,joints,butt cap,joint rings are all threaded on
the cue
I build each cue to last a lifetime
Russ

http://
