I am going to install a tip on my jump break cue,
" is there a "GLUE" side...
one side in plain, the other has an "S" on it???
thank you
" is there a "GLUE" side...
one side in plain, the other has an "S" on it???
thank you
Samsara Jump break Tip QUESTION
- Thread starter Duane Remick
- Start date
All the Samsara jump/break tips I have done, which are the phenolic tip with the leather center, are domed making it self explainatory as to which side to put the glue on. Never noticed an "S" on one side of the tip but I haven't looked that close.
Is your Samsara tip not domed ??
Is your Samsara tip not domed ??
I think you may be mixing up the samsara with a icebreaker
I don't think it matters which side gets glue.
I normally glue the logo side
I think you may be mixing up the samsara with a icebreaker
I don't think it matters which side gets glue.
I normally glue the logo side
I normally glue the other side
Flip a coin,
Gary
I think you may be mixing up the samsara with a icebreaker
Hmmmmm, VERY possible,lol
. I have one of each tip at the house, when I go home for lunch I will try and look at each of them.
I think you may be mixing up the samsara with a icebreaker
Upon further investigation on the internet, as usual, once again you are correct, I was confusing the two. No need to even wait to get home to see,lol. Thanks for clearing it up for me. :thumbup:
Lol
Anytime lee
The sanded side is intended to be "pre-prepped" for gluing. It will play the same either way.