saw machine

CDs cues

CDs cues

AzB Silver Member
Silver Member
I have a early Sirca saw setup that I don't use anymore. I built the table on top of a cheap Hitachi table saw and used it for a couple of years to ruff cut butts. I did my final pass on a lathe. The motor works but has a bent shaft so has a wobble and it drags to start. I was going to put a new motor on it and put a adjustable taper bar on it to do shafts. I have a new toy so no longer needed. $350 for the machine or $500 for machine, table and saw. If you want just the machine I will pack it and only charge for shipping. If you want it all, I say pick it up only would be best here in Upstate S.C. Thanks,
Lee D
864-642-5604


DSCF0590.jpg

DSCF0589.jpg

DSCF0592.jpg
 
its probably best you grabbed it...i would have another machine i don't know how to use.
 
CDs cues said:
I have a early Sirca saw setup that I don't use anymore. I built the table on top of a cheap Hitachi table saw and used it for a couple of years to ruff cut butts. I did my final pass on a lathe. The motor works but has a bent shaft so has a wobble and it drags to start. I was going to put a new motor on it and put a adjustable taper bar on it to do shafts. I have a new toy so no longer needed. $350 for the machine or $500 for machine, table and saw. If you want just the machine I will pack it and only charge for shipping. If you want it all, I say pick it up only would be best here in Upstate S.C. Thanks,
Lee D
864-642-5604


DSCF0590.jpg

DSCF0589.jpg

DSCF0592.jpg
Click to expand...

Best deal I have ever seen on one.
 
i was looking at the kers manuscript last night and this looks exactly like it...did you build it from his drawings/specs?
 
You must log in or register to reply here.
Back
Top