Schon shaft insert

[ken ken quarter]

Can this be heated and screwed out for replacement or just drill it out,plug and retap for the new insert? The original has apparently unglued and backed out about 1/16" then siezed again leaving an extra long pilot going into the SS joint collar. How would you fix it? Thanks Ken Ken.

 

[rhncue]

Can this be heated and screwed out for replacement or just drill it out,plug and retap for the new insert? The original has apparently unglued and backed out about 1/16" then siezed again leaving an extra long pilot going into the SS joint collar. How would you fix it? Thanks Ken Ken.

I, myself always just bore, plug and use a new insert. I guess you could insert a pin, and heat to break down the glue but I've always done it the other way.

Dick