shaft made for joss west cue

[canwin]

I have a 13.5 mm shaft that was made for an early 70's Joss West cue I had but have since sold that I forgot to add to the sale. It was made by Dick Neighbors(Chris Bartum's cuemaker). Hard maple shaft. Great shaft! $100.00.

 

[half fast bankr]

13.5mm?! Damn, I could barely get my hand around that, lol! Bet it hits a ton!
What's the weight on this thing?

 

[canwin]

13.5mm?! Damn, I could barely get my hand around that, lol! Bet it hits a ton!
What's the weight on this thing?

I'll weight it and post it when I confirm it. It has a stout hit to it, that's for sure ..!

 

[canwin]

13.5mm?! Damn, I could barely get my hand around that, lol! Bet it hits a ton!
What's the weight on this thing?

The shaft weights 4.1 ounces and has the same taper Buddy Hall uses which is that it has the long same taper as the tip before it tapers to a thicker diameter.

 

[tduncan]

PM sent....

 

[canwin]

close up of the collar

 

[canwin]

The shaft rolls straight and true. It's 29 inches long and measures .838 with a micrometer and .840 diameter with a dial caliper at the joint.

 

[12squared]

What thread is it, 5/16-14 or 5/16-18?

 

[mamono]

Looks like 5/16x14 from the picture...