Taper Bar

billy-ks

AzB Silver Member
Silver Member
Does anyone know if you can buy a taper bar for a Cueman lathe? I am looking for a shaft taper bar with a pro taper bar. Thank you
 
you can buy the attachment separately yes. the way those work is you have a flexible strip of delrin that your cross slide rides against and you can set it to whatever taper you want.
 
I’ll ask the same question but for a Mid America lathe. I assume it should. MA doesn’t offer one. Maybe they will with the new owner but I do not see one yet.
 
Does anyone know if you can buy a taper bar for a Cueman lathe? I am looking for a shaft taper bar with a pro taper bar. Thank you've
Contact Chris...he will give you a yes/no. It's not going to be cheap. I have Micro ll... I regret not adding one at build time. Also have a large bore MidAmerica...did not want or need it then but regret it now
 
If you add a taper bar, you will need a new cross slide with an extra deck that has a spring loaded deck to engage the bar with a built in bearing. You will also need risers for the head stock, tail stock, and all steady rests.
 
If you add a taper bar, you will need a new cross slide with an extra deck that has a spring loaded deck to engage the bar with a built in bearing. You will also need risers for the head stock, tail stock, and all steady rests.
When I ordered the lathe If the bar wasn’t added when built it was very expensive to add later.
 
Yeah buying after I had a mid size i think cost me around the 900 area. When you buy the kit it comes with all those riser blocks and extra slide, everything needed to put on your lathe. Call Chris and he'll get you taken care of.
 
Back
Top