Dear All,
There are certain tips on the market now that when after installing and I am shaping them the layers fall off. I use a brand new blade. I understand that they say to not generate too much heat while shaping by slowing the lathe down. I also put a fan on the tip. But it still happens from time to time. Should I use one of the auto tip shapers?
Thank you in advance,
Jon
There are certain tips on the market now that when after installing and I am shaping them the layers fall off. I use a brand new blade. I understand that they say to not generate too much heat while shaping by slowing the lathe down. I also put a fan on the tip. But it still happens from time to time. Should I use one of the auto tip shapers?
Thank you in advance,
Jon