I would like to trade one of my less expensive cues for a quality case.....GTF ,It's George JB . or something similar . I have a Dufferin conversion worth $300 or a Carter bacote sp worth around $450 or so . I am looking for a 2 x 4 or 2 x 5 at the largest .
Thanks'
Chuck
Carter....built in 06 .4 points of bacote into maple . Juma joint with a 3/8 x 11 pin, on 12.3 mm shaft with Ultraskin ivory tip .A very solid and straight full splice cue . The finish is a bit thin at one of the points but not worth the cost of a refinish .
The cue is 58 in,even 29 in butt and shaft .The butt weighs 14.3 oz, the shaft 3.5. The points are pretty even,one is maybe 1/16 " longer than the others. Cue is straight together and apart.
Thanks'
Chuck
Carter....built in 06 .4 points of bacote into maple . Juma joint with a 3/8 x 11 pin, on 12.3 mm shaft with Ultraskin ivory tip .A very solid and straight full splice cue . The finish is a bit thin at one of the points but not worth the cost of a refinish .
The cue is 58 in,even 29 in butt and shaft .The butt weighs 14.3 oz, the shaft 3.5. The points are pretty even,one is maybe 1/16 " longer than the others. Cue is straight together and apart.
Attachments
Last edited:
