Wanted: old set of Mcdermott joint protect

Mike,

I have 5/16 x 14, and uni-loc , and a radial set sorry no 3/8 x 10

I don't use them so I wasn.t sure

Sorry,
Joe
 
Tim-n-NM said:
Are you looking for the old wood ones or the new plastic ones? I have both!!
Click to expand...


I did not know they had wood ones. The pin is 3/8X10 and it is 1 1/4" long.
how much do you want for them?

Thanx
C.H.:)
 
daytonajoe said:
Mike,

I have 5/16 x 14, and uni-loc , and a radial set sorry no 3/8 x 10

I don't use them so I wasn.t sure

Sorry,
Joe
Click to expand...

That's Ok..Thank you for looking.:)

C.H.
 
CaptainHook said:
I did not know they had wood ones. The pin is 3/8X10 and it is 1 1/4" long.
how much do you want for them?

Thanx
C.H.:)
Click to expand...

I wondered about the pin length too. There are some inexpensive plastic joint protectors out there but I don't know if any of them are deep enough for the McD pins. I went ahead and paid the money to get the McDermott aluminum and plastic ones.Pain in the butt if you have two shafts since they only sell the butt/1 shaft set.

Terry
 
CH, we have a set for you PM your address to me and I will send them out. Cost tell Dale at the Flamingo that John & Jim said hello from Waldo's
 
CaptainHook said:
Anyone have a old set of 3/8-10 joint protectors that you want to get rid of cheap.:)
Click to expand...

I have a couple of sets of these.......let me know if you need em.

left set....purpleheart
right set...Ebony(I think)

The wood is darker on both sets in person.....the flash really lightened them up.

George
 

Attachments

  • joint protectors a.JPG
    joint protectors a.JPG
    60.3 KB · Views: 95
Last edited:
George said:
I have a couple of sets of these.......let me know if you need em.

left set....purpleheart
right set...Ebony(I think)

The wood is darker on both sets in person.....the flash really lightened them up.

George
Click to expand...

Thanx, Waldo's has me covered.

"CH":)
 
You must log in or register to reply here.
Back
Top