I recently got a high end cue and I love it but the weight distribution is very different from my old cue. The new cue has much more weight throughout the whole butt. My concern is that if I have the cue maker take out the weight bolt it will make the butt more front weighted. I will also be buying a low deflection shaft for the cue and they weigh less than the traditional maple shaft it currently uses so I am afraid that the weight distribution will be very off.
Is it an irregular request to ask a cue maker to remove some of the weight from the butt near the joint as well as remove the weight bolt? Is this even possible?
Is it an irregular request to ask a cue maker to remove some of the weight from the butt near the joint as well as remove the weight bolt? Is this even possible?