What type of "radial pin" is this?

[SeniorTom]

Can somebody tell me what type of radial pin is on this particular cue? It was made in the Philippines, it's not an overly expensive cue, but I need some pin protectors for it.

 

[Kim Bye]

Probably an Asian ball pin.

 

[jokers_wild96]

Have you tried using regular radial joint protectors.

 

[SeniorTom]

Have you tried using regular radial joint protectors.

I have a spare joint protector, the male portion, that goes into the shaft end, and I think it is a radial. It works fine, but I need the butt and protector as well. It's just a bit difficult for me to identify this single piece that I have as to what type of thread it actually is. Here is a picture of the butt end to identify?

 

[jokers_wild96]

It looks like its a knock off radial. But if the male jp fits in the shaft then the female jp should fit as well.

 

[SeniorTom]

It looks like its a knock off radial. But if the male jp fits in the shaft then the female jp should fit as well.

The only problem with that is I lost the female portion and can't find it. So I have to buy a new set. I have it on order, from amazon, so I hope it's the right one.

Amazon.com

 

[blokid]

Can somebody tell me what type of radial pin is on this particular cue? It was made in the Philippines, it's not an overly expensive cue, but I need some pin protectors for it.

IMO, It's 3/8x8 pin bro.

 

[SeniorTom]

IMO, It's 3/8x8 pin bro.

Yes it appears that that is the protector that will work for me. It is on order, won't be here till after Christmas, and I will post results. Thanks for your help!