Wtb: .030 Veneer Rings

[leon sly]

Looking To Buy .030 Veneer Rings Colors Natural....indigo Blue......red...... For J..i..b

 

[leon sly]

Bump For Some Help

 

[Rodney]

I don't know about specific colors, or thickness, but Prathers and Arnot are selling veneer rings. I would start with them.

 

[leon sly]

Thanks, for your help but prather only has the.......joint......but..... pieces no inner.

 

[dave sutton]

buy veneers from martin. jazz and pool. i cut them into 1.5'' square use titebond III then epoxy them to my phenolic chuck up phenolic after drying and broe out middle. slide on and take down.

 

[Cue Crazy]

Glueing them as Dave mentioned will certainly get the job done, but Here's how I do them. I just glued a couple of nic/silver rings to a a strip of birch, and cut them out on My panto. Works really well. I'm gonna cut a v-groove template from this one some day, but I've had no problems using It as is, and staying against the rings with the stylus so far, so I have just not bothered to cut one from brass or corian yet. The trick is to turn a stylus to the same diameter as the endmill Your using. By doing that they come out the same size as the Nic/Silver rings.

The black ring was cut from dyed venner. The white ones are cut from Ivory, and the centers make good inlays for the tops of JP's.

I don't have the veneer you need in stock, but if you have some, or can get It to Me, and I can be of service, then I'd be glad to cut some out for you. Just Pm if I can be of help.


Greg

 

[dave sutton]

i glue one set to the ivory ring and one set to the ebony ring bored then slid them on like normal