wtb break shaft

[duece6610]

I have 2 cues i would like to use as a break but i need a new shaft for either one, I'm looking for either a 3/8x10 joint around .840, or a 5/16-18 same joint, for around 70 or 80. anybody have anything?

 

[huysmall]

I have 2 cues i would like to use as a break but i need a new shaft for either one, I'm looking for either a 3/8x10 joint around .840, or a 5/16-18 same joint, for around 70 or 80. anybody have anything?

I have used one, Flat 5/16x18, diameter of joint collar is .835. Dead straight.
The ferrule is bakelite, with Samsara Break/Jump tip.

Asking $79 (shipped)

Huy Dang

 

[duece6610]

thanks

thanks but if anything i need it bigger if i vary away from it bc of how i break it tear up my hand wit the lip it would leave

 

[duece6610]

bump

bump.......................

 

[duece6610]

bump

bump>>>>>>>>>>>>>>>>>>>>>>

 

[a9ballbr8k]

I have a 3/8-10 shaft that suits your needs. Bob from DZ cues made it. It has a fairly stiff taper. The taper plays well for both playing and breaking. It is in almost new condition. It has a black ferrule and a pressed triangle tip that will never mushroom. I have been playing with pressed triangles for some time and use my playing cue to break with a lot. I have never had one mushroom on me yet and I break hard. I'm asking a little more than what you requested but I can promise you will not be dissapointed. Shaft can be seen here.

http://forums.azbilliards.com/showthread.php?t=229880

And by the way, it is exactly .840 on the money

 

[duece6610]

thanks

thanks that is alittle more than i was wanting to spend on since all im doing is breaking with it, but if nuttyn turns i may consider it