Hello
Im looking for a very good custom made cue shaft with ivory ferrule. I like hard, stiff hitting shafts.
Im not really expert about cue makers and theyr shafts.So I appreciate any help or advise!
I´m from germany but my friend has an APO address so it is not a problem to send over here.
My cue datas: got 5/16x14 thread.
And the joint diameter:
outside has 0,840 inch = 21,33 mm
inside has 0,474 inch = 12,04 mm
deepness (oppsite cone) 0,208 inch = 5,28 mm
height of thread cone 0,986inch = 25,05 mm
Thanks and sorry for my writing mistakes !!
Regards
Im looking for a very good custom made cue shaft with ivory ferrule. I like hard, stiff hitting shafts.
Im not really expert about cue makers and theyr shafts.So I appreciate any help or advise!
I´m from germany but my friend has an APO address so it is not a problem to send over here.
My cue datas: got 5/16x14 thread.
And the joint diameter:
outside has 0,840 inch = 21,33 mm
inside has 0,474 inch = 12,04 mm
deepness (oppsite cone) 0,208 inch = 5,28 mm
height of thread cone 0,986inch = 25,05 mm
Thanks and sorry for my writing mistakes !!
Regards