WTB- Nylon inserts like Hueblers

[jmizzo]

Does anyone have any old stock left? I have one lead, but only want to use that as a last resort. Looking for enough for like 3 to 4 inserts. Let me know what you have.

 

[macguy]

Does anyone have any old stock left? I have one lead, but only want to use that as a last resort. Looking for enough for like 3 to 4 inserts. Let me know what you have.

I have made some shafts for Hueblers. What I did was use a rod of Delrin. After cutting the OD threads I installed in it the shaft. Then finished it off and drilled and tapped the thread.

 

[ddcuerepair]

This is what I have used in the past to make the nylon inserts.
http://www.nutty.com/12-13-Nylon-Threaded-Rod-3-ft-36-inches_p_13665.html

 

[jkan101]

insert

Or you can try here for nylon rod......http://www.mcmaster.com/#nylon-rods/=q41fri

 

[Busbee Cue]

Does anyone have any old stock left? I have one lead, but only want to use that as a last resort. Looking for enough for like 3 to 4 inserts. Let me know what you have.

It is pretty simple to make one. Something similar to the picture except use
nylon instead of phenolic. Use a good slow cure epoxy. Once it is cured just bore and tap for your pin. I have done quite a few of the nylon inserts and have not had one come loose yet and some of them were done 15 years ago.