WTB: OB-1 Shaft for Gulyassy Radial Pin

[LightWeight]

I am looking for a OB-1 shaft that will fit a Gulyassy Radial Pin (same as the pin used on original Sledgehammer cues). I think it is different than a standard radial pin and I may need to get a OB-1 blank, then have it tapped, but thought I would see if anyone has something.

Thanks,
Craig

 

[pooljunkie75]

I am looking for a OB-1 shaft that will fit a Gulyassy Radial Pin (same as the pin used on original Sledgehammer cues). I think it is different than a standard radial pin and I may need to get a OB-1 blank, then have it tapped, but thought I would see if anyone has something.

Thanks,
Craig

Here you go.... Check it out.. Let me know..
http://forums.azbilliards.com/showthread.php?t=173054

Thanks
Bruce

 

[LightWeight]

I was really looking for a black Joint collar but could be ok with brown. I am just not sure that it will fit the Gulassy cue I have. I have a feeling that the radial pin is slightly different.

 

[ndakotan]

different pins

I am looking for a OB-1 shaft that will fit a Gulyassy Radial Pin (same as the pin used on original Sledgehammer cues). I think it is different than a standard radial pin and I may need to get a OB-1 blank, then have it tapped, but thought I would see if anyone has something.

Thanks,
Craig

Gulyassy has an ACME pin that is slightly different than standard radial pins. He is probably the only one with the correct tap. He is pretty easy to talk to if you look him up and call him. I have a OB-1 for radial pin, but it does not fit the ACME radial pin.

Brian

 

[vanthonyv]

If you really want to get an OB-1 Shaft then just buy a partial and have Mike fit it to your cue for you. Mike is honestly a really stand up guy and you can't go wrong with him doing any work for you. His web page is http://www.babysproshop.com/mikeGulyassy.php and his shop is located in south carolinia. hope this helps.