WTB stitched ring schon R3 or R4
- Thread starter J Layer
- Start date
Contact Wade
He has a couple differant models.
Nick
He has a couple differant models.
Nick
He has a couple differant models.
Nick
Thanks Nick!I'll pm him
R-11............ $595 shipped
shafts are 4.1 oz 30 inch's 12.26 at base of ferrule
2nd is 4.0 oz 29 inch's 11.98 at base of ferrule
Shafts have a very small roll out to them. Tips never
leave the table. They need clean and retipped this
would help on the roll.
The butt is 15.5 and the points are sharp but not even. The cue has a lot of play on it. Looks like the
butt cap was replaced and has a small chip at the bottom of it. The butt rolls great.
I was going to get it refinish and make a new shaft
new price would been $850 shipped.
shafts are 4.1 oz 30 inch's 12.26 at base of ferrule
2nd is 4.0 oz 29 inch's 11.98 at base of ferrule
Shafts have a very small roll out to them. Tips never
leave the table. They need clean and retipped this
would help on the roll.
The butt is 15.5 and the points are sharp but not even. The cue has a lot of play on it. Looks like the
butt cap was replaced and has a small chip at the bottom of it. The butt rolls great.
I was going to get it refinish and make a new shaft
new price would been $850 shipped.
Last edited: