Steve Lomax did a very fine job, applicating this new black lizzard embossed leather wrap! (The original one was brown. IMO Black fits much better to By al-capool Jan 20, 2014 0 Comments
Finished tip trimmed, and polished the outside with some 600 grit paper. This is a snooker tip and is Ø9.55 mm By conetip Jan 17, 2014 0 Comments
Trimmed front radius and moved around to the radial diameter stop, ready for the continuation of the pass. By conetip Jan 17, 2014 0 Comments
Set up tip on mandre, Tip radius and diameter stop have already been set on a set up piece. By conetip Jan 17, 2014 0 Comments
Assembled unit with router and 8 wing cutter, set to penny radius. By conetip Jan 17, 2014 0 Comments
Cutting the 3mm wide slide through for the Router Clamp. Slitting saws if available makes for a quick and easy way of slitting these sort of things. By conetip Jan 17, 2014 0 Comments
Using a block for support on the back jaw face. Drilling the M6 hole for clamping the router.I drill down with a 6.1mm drill just pass the slot mark.T By conetip Jan 17, 2014 0 Comments
Flipped block over , leaving the same face against the vice jaw, so only need to find the hole center, in X (long axis). Y has not changed, C' bore to By conetip Jan 17, 2014 0 Comments
Spot drill and drilling the capscrew holes. Drilled from under side, as that is the important side to match Taig Slide T slot. By conetip Jan 17, 2014 0 Comments
Checking the fit of the Taig slide into the bottom side of router mount. By conetip Jan 17, 2014 0 Comments
Centralizing the router mount hole to the width of the mount block, using a Universal mic to check the wall section. By conetip Jan 17, 2014 0 Comments
Making-Router-Mount,1st set up for squaring block from turned reference face. By conetip Jan 17, 2014 0 Comments
![IMG 0461[1]](/media/img-0461-1.12448/full)
![IMG 0460[1]](/media/img-0460-1.12447/full)
![IMG 0445[1]](/media/img-0445-1.12410/full)