Help With Pockets On An Acme

Al Coholic

Al Coholic

Wrap it like it's yours.
Silver Member
I have a Customer with a 1920's Acme Pool Table and his Pockets Are Shot.
Imperial Told me it's takes a Standard #6 pocket.

The Pockets Bolt in fine but it makes the rails too short to fit on the table.

From what it looks like is that the #6 pocket is 4in from point to point.
The Acme pocket is 4 1/2 inches from point to point.

Any Advice?
 
Al Coholic said:
I have a Customer with a 1920's Acme Pool Table and his Pockets Are Shot.
Imperial Told me it's takes a Standard #6 pocket.

The Pockets Bolt in fine but it makes the rails too short to fit on the table.

From what it looks like is that the #6 pocket is 4in from point to point.
The Acme pocket is 4 1/2 inches from point to point.

Any Advice?
Click to expand...

i would send the Irons out to Hood and have new leather sewn on. This way you know they will fit.
 
Al Coholic said:
I have a Customer with a 1920's Acme Pool Table and his Pockets Are Shot.
Imperial Told me it's takes a Standard #6 pocket.
The Pockets Bolt in fine but it makes the rails too short to fit on the table.
From what it looks like is that the #6 pocket is 4in from point to point.
The Acme pocket is 4 1/2 inches from point to point.
Any Advice?
Click to expand...

Imperial ?? :rotflmao1:
As Pat mentioned - call Hood at 800-962-9695 and ask for Alex
 
Al Coholic said:
:confused: Sorry, Imperial is the only Place in So. Cal. Around Since RC Designs Went Out Of Business.
Click to expand...
Reckon you need to look outside the country of California.
Too bad RC went under. D&R was supposed to buy them out.
That leaves Hood as the only major US pocket mfg.
 
You must log in or register to reply here.
Back
Top