Here is a simple cue I just completed for a customer, I turned this from a 1.75 thirty inch dowel of Zebra Wood. I started turning this dowel in 2007, and finish the final turn last November. The cue partially cored for reinforcement at the cues joint. The core extends fifteen inches from the joint, and the core and an extra long 3/8-10 pin (5 inch) allowed me to control the balance point of this cue by adding extra weight where it was needed for a finished weight of 18.5 oz.
The customer will see the finished product later to night, I hope they are as happy with the results as I am.





Have a good night
The customer will see the finished product later to night, I hope they are as happy with the results as I am.





Have a good night
Last edited: