Cleaning and Finishing Lathe

customcuelathe

customcuelathe

AzB Silver Member
Silver Member
Last summer I build 3 finishing lathe Headstocks, using a Taig headstock housing, a 3/4" keyless chuck with solid spindle. The idea behind this lathe was: in tournaments, cue repair guys make more money based on how fast they can turn around shafts (tips, cleaning, ferrel, ect.) So if you have a dedicated lathe for cleaning and one cue lathe dedicated for repair.
With that said, I am planning to sell 2 of the 3 Headstocks or lathes.
The price of the headstock with 1/3HP DC motor is $325
The headstock, 38"-48" bed, and a tailstock with concave live center $465
Add 11 PCM driver pin set $185

If this lathe is purchased with any other repair lathe, buyer will receive $100 off plus discounted shipping.

Basic repair lathe with 15mm bore taig headstock starting @ $799
With Big Bore headstock starting @ $995.
Dual live center $35
QCTP with 4 holders & cutoff blade $100
Best Regards
Bassel 248-884-4469
www.customcuelathes.com
Customcuelathes@yahoo.com
ImageUploadedByTapatalk1356336959.756881.jpg
ImageUploadedByTapatalk1356336990.424226.jpg
 
large headsatock

I use a taig bed 6' is there a large headstock that can be used with
out raiser blocks if you have how much I could do so much more
 
mos082 said:
I use a taig bed 6' is there a large headstock that can be used with
out raiser blocks if you have how much I could do so much more
Click to expand...

My tall big bore headstock with 1/3HP motor 24 point starts @ $599
With dual chuck @ $699

Best regards
Regards
 
Last edited:
You must log in or register to reply here.
Back
Top