Help with replacing cushions on Irving Kaye table

R

Reformedcitykid

New member
Hi all, I’m new to the forum and was hoping to get some guidance from the pro’s! I am currently renovating an Irving Kaye 7’ table at work (I believe it is the Apollo series). I am stuck trying to replace the cushions, as I cannot for the life of me figure out what profile to get. I purchased K-66 rubber, but it seems to be significantly bigger than the existing rubber.

Upon further investigation I found that the rail system uses profiled rubber cushion blocks to sit in the rail system instead of the normal table cushions. I found you can buy replacement rails (with cushion) from Penguin Amusement, but cannot find if there’s anywhere just to buy the correct rubber. Any help on what profile I need, what cushions/rubber to buy, or any other guidance would be much appreciated!!

Photo album of rubber & rails
 
Reformedcitykid said:
Hi all, I’m new to the forum and was hoping to get some guidance from the pro’s! I am currently renovating an Irving Kaye 7’ table at work (I believe it is the Apollo series). I am stuck trying to replace the cushions, as I cannot for the life of me figure out what profile to get. I purchased K-66 rubber, but it seems to be significantly bigger than the existing rubber.

Upon further investigation I found that the rail system uses profiled rubber cushion blocks to sit in the rail system instead of the normal table cushions. I found you can buy replacement rails (with cushion) from Penguin Amusement, but cannot find if there’s anywhere just to buy the correct rubber. Any help on what profile I need, what cushions/rubber to buy, or any other guidance would be much appreciated!!

Photo album of rubber & rails
Click to expand...
call ken at classic billiards.
 
The profile is A48 or #48.
Measure the back side of the cushion which should be 1 1/16"
I think you can get a set of cushions at Classic Billiards or Muellers
 
You must log in or register to reply here.
Back
Top