Recent content by Knels

Its better to be heating a room initially, then run the dehumidifier at the same time. The dehumidifier cools down the air to extract the water. If you’re able to seal the room, then you don’t really have to do this all the time, you will see -30% in no time

Im just about to tackle this job. What kind of glue should i use? Should i glue it to a tip first then install and trim?

Clean the cue joint, threads then give it a try. Some brand new cues even need this sometimes

Im about to go up to a 12.9 revo from a 12.4. Ive been having difficulty on rainy humid days, on some pretty wretched tables + old mismatched ball sets. It felt like i needed to move the ball around easier. The plan is to stick with the 12.4 on newer equipment. I play tournaments in a lot of...

What would be the best conditions to seal? Humid or dry?

This was on a classified ad, but the place was a 4hr drive away. There were old Brunswick balls on either end, but yea the cues are completely glued together 😆.

Came across this, which believe it or not was transformed into a table light. Are some of those veneered cues any good? Worth looking into?

I agree with this, love my wx700 but im having the worst time moving the ball around for nineball. Not all nights just most. Once upon a time i did shoot with a z2/p3. Been thinking about it a lot lol

All i know is that in Vegas, a very high percentage of the professionals playing the diamond 10 ball were using it. I tried it on a valley and couldn’t get the hang of it. Probably needed some more time with it

The older ones can warp

Tried to pm u Hey i tried to pm u but im not sure if it went through, give me a shout-thx

Don’t know why i cant reply to all the pms, email me at raniehtenhawi@hotmail.com

Going to Vegas tomorrow, i have a wavy ignite , stock zan medium tip with two months use, looking for 500$ us. Will put the money towards another vendors wares. Send me a pm, will be there for a week thx

Dont know about muellers but mezz butts are on the thick side. Might want to check the difference in diameter.

Try checking out eric brissett on fb, he does cnc work but i know he put silver inlays into a nice cue ive seen once. Hes french from Quebec