Recent content by obe1

200 DOLLARS CASH MEET UP SHOOTERS BILLIARDS —BURNSVILLE MN. THANK YOU

It worked now. Thank you very much sir!

I will see if he can do this--again THANK YOU Chris for taking the time to help--

Thank you Chris--I thought so--Can a Pin thread measured properly to correct this issue and replaced if needed or do I have to live with this ?

Thank you

Thank you

I just bought a new custom cue butt with 3/8 x 10 pin made to match up to my custom old growth maple shafts. Now the shafts seem to fit looser on this pin when I am tightening them down but nice and tight on my older cue which is a McDermott D-2 My question is are there multiple different...

Does anyone know if Steve is still in business or have contact info? Thank you

Thank you for your help sir...

I have always use my phone to my email...I think my old computor has issues--I tried on Facebook and same results just a black picture when uploaded--

Must be on my end--very strange

Has there been a change ? I have posted pics since 2010 without issue.

thank you

-Had a new inserts installed and mech said collars were loose so he reinstalled them. Now the shafts has lift on tip end when attached to any of my cue butts. They roll straight alone- These are Steve klapp old growth shafts purchased 2010 -Never had a issue till now. Appreciate your...

RIP Danny...You did good