Recent content by sixballrun

  1. sixballrun

    cue repair lathe(s)

    Sold! ......................
  2. sixballrun

    cue repair lathe(s)

    i've had a few pm's already asking where in canada i am, i live in winnipeg manitoba,
  3. sixballrun

    cue repair lathe(s)

    Getting rid of my lathe(s) 48” hightower lathe bed taig headstock with hightower 5/8” spindle, (plus original taig spindle) with 3 jaw aluminum chuck and extra set of soft jaws. Taig lever tailstock with ½” keyless chuck and taig live center Headstock and tailstock on risers, have extra...
  4. sixballrun

    Updated Special offer to all AZ members

    how much for the headstock without the motor?
  5. sixballrun

    best option for lathe

    chris hightower will sell you the spindle and bearings for the taig lathe at a very reasonable cost so you can put a shaft through for tips and ferrules. i got one from him and the fit is as precise as it gets. the threads on the spindle are the same as a normal taig as well.
  6. sixballrun

    wooden cases

    these are, in my opinion the nicest wood cases i have ever seen. http://www.breakwideinc.com/washingtonworkswood/mainpages/poolcuehome/index.htm
  7. sixballrun

    wooden cases

    thanx for the compliment, pm sent
  8. sixballrun

    wooden cases

    thanx. if you've ever seen the live sh*t binge and purge boxed set, that is what i modeled it after, i made another one for a buddy as a gift, (he is a bigger met fan than me!) but his is 02 and stage left (he is a lefty) as opposed to 01 and stage right (mine). it now sits as a display beside...
  9. sixballrun

    wooden cases

    a couple more...
  10. sixballrun

    wooden cases

    i wouldn't say these are the nicest wood cases, but here are some that i made a long time ago.
  11. sixballrun

    tap for Uniloc

    i have been using a cue with a uni-loc pin exclusively for three years, i play league once a week (twice last year) and practice once or twice a week for 3-4 hours a night, and i have NEVER had it come loose during play. i read somewhere that joint protectors are a MUST for uni-loc, so that...
  12. sixballrun

    shaft

    my guess is it would be pretty simple. taper it over sized, then run the router vertically without the cue spinning, using indexing to get the flat spots.
  13. sixballrun

    Need unbiased Opinion

    here's a good review from a respected cue maker, look at the second post in this thread. http://www.easypooltutor.com/modules.php?name=Forums&file=viewtopic&p=119928&highlight=cue+lathe+review#119928
  14. sixballrun

    Where can I buy stack leather?

    http://www.cuestik.com/
  15. sixballrun

    stack leather wrap not quite right...

    thanx for the replies, pm sent to corey
Back
Top